← Blog
Interactive tool · 2026

Nodal Pro — Nodal Analysis Simulator

Web well-productivity simulator: it intersects the reservoir inflow curve (IPR) with the tubing lift curve (VLP) to find the well operating point. Choose the solution node (bottomhole, wellhead or downstream of the choke), compare against a well test (oil, water and gas rates, tubing and downstream pressures, choke) to calibrate the choke, IPR and correlation, and model gas lift and ESP, pressure traverse, PVT and sensitivities, in Mexican metric units (kg/cm², °C, m, m³/m³) or field units — no installation needed.

Vogel Fetkovich Darcy Beggs & Brill Black-oil PVT Gas lift ESP Plotly
Interactive tool · Production Engineering

Nodal Pro — Nodal Analysis

IPR + VLP · Operating point · Pressure traverse · Sensitivities · CSV export

Composite Vogel Fetkovich Beggs & Brill (1973) Standing PVT Gas lift ESP
Open Nodal Pro ↗

Opens full screen for the best experience

What is it for?

Nodal analysis splits the production system into two parts that meet at a node — here, the bottom of the well. Inflow describes how much the reservoir can deliver at each bottomhole pressure; outflow describes the bottomhole pressure the tubing needs to lift that rate to surface. Where they cross is the rate the well will actually produce.

Inflow (IPR)

Composite Vogel (linear above Pb), Fetkovich, or J from radial Darcy flow including skin S. Calibrated from a well test or a known PI.

Outflow (VLP)

Beggs & Brill (with or without Payne correction) or homogeneous, integrating the gradient from wellhead to bottom, with flow pattern and holdup per segment.

Black-oil PVT

Standing (Rs, Pb, Bo), Vasquez-Beggs above Pb, Beggs-Robinson (μo), Hall-Yarborough (Z) and Lee-Gonzalez-Eakin (μg).

Artificial lift & sensitivities

Gas lift (performance curve and optimum injection) and ESP (pump curves by frequency, recommended range, intake pressure, gas at intake and power). Sensitivities to wellhead pressure, tubing, water cut, GOR, reservoir pressure, skin, gas-lift rate, frequency and stages.

How to use the tool

01

Describe the reservoir

Reservoir pressure and temperature, plus a well test (q, Pwf), the PI, or Darcy data (k, h, S). Pb is calculated if left blank.

02

Enter fluids and completion

API gravity, gas gravity, GOR, water cut; depth, tubing ID, wellhead pressure and temperature, and the artificial lift system (gas lift or ESP). Everything recalculates instantly.

03

Read the operating point

Rate, Pwf, gas, drawdown, and estimated choke (Gilbert) or ESP power. Check the pressure traverse to see how much is hydrostatic versus friction.

04

Run sensitivities and share

Try scenarios, export CSV or PNG, and copy the link: the full scenario travels in the URL.

Reference and learning tool. For design or operating decisions, validate against a commercial simulator calibrated with well tests.